Most of the time, businesses would spend a lot of money to purchase their forklifts. It is vital, therefore to take good care of your machine to protect your investment into the long run. It is really a good idea to know the procedures that are carried out in the care and maintenance of this piece of machine.
Amongst the best ways to tell how good the engine is performing is by starting the lift truck up and listening carefully to see how it works. Like for instance, if there are any misses or knocks, the machine is defective and this must raise several concerns. What's more listen closely for any squealing noise which come from the belts because these noises would provide you with a lot of information.
When performing maintenance, several of the main components you will need to pay attention to comprise the safety warning devices, horn, the overhead guard, the lights and the gauges. Any faulty components or burnt out light bulbs must be replaced as soon as they are noticed. It is also imperative to check the wiring.
After the above parts have been inspected thoroughly, proceed to the battery compartment to be able to see if the terminals are clean. If the terminals are not clean, be sure to clean them properly. Every cell of the battery must be checked so as to ensure the fill level is topped up to the regulated amount.
The next step is to drain all of the oil out of the machine and after that change the filters. The hydraulic filter, the transmission filter and the fuel filters must be frequently replaced. Before fitting them, be sure to write the date on the new filters by using a permanent marker to be able to keep track.
Once the oil change has been done and new filters have been fitted, visually check the drive axle from underneath the machine. Be sure to grease the axle if there is any grease fitting. Check the belts on the engine for any cracks or frays. If you find any, fix the problem accordingly. Then, inspect every other part of the machine like the wheels. If any type of fault or issue is detected, be certain to deal with it immediately so as to make sure the machine is working at its safest and optimum levels.